Goulds 1151AB21HM06, Booster System with Tank, Outdoor Controller and e-HM Pump

Description

Goulds Aquavar e-ABII Variable Speed Constant Pressure System
This e-AB2 variable speed pump controller and complete booster package kits, provide an economical answer for municipal water district customers with low water pressure. Both domestic and light commercial applications can benefit. As water use increases, the controller changes pump speed to maintain pressure. Large supply tanks are eliminated and less wear and tear on your pump and motor. Think of it as "Cruise Control" for your pump!
Package includes
:
Pump e-HM, 6 stages
Pressure tank (2 gals), model V6P
1 HP variable speed controller (1AB2); Nema 3R
Transducer
Controller Features
1 HP variable speed controller
Will work on single phase, 115V input power
Output power up to 230V three phase (based on input voltage). Motor rated for 208-230V, ±10%
Maximum output current is 4.2 amps – 1AB2 (1 HP)
Up and down input control buttons to set pressure
Signal lights to indicate power on, pump running, inverter stopped, pump stopped, standby, faults/errors
Over 95% electrical efficiency at full load
Protection against short circuit, under voltage, overload, motor temperature, dead heading, run out, suction loss, sensor fault, bound pump, over voltage, static discharge
Suction loss/run out is set for minimum 10 psi at discharge!
Ambient temperature is 34°F to 104°F
Maximum humidity is 95% at 104° F, non-condensing
Avoid mounting in areas with excessive dust, acids, corrosives and salts
UL, CUL, CE approvals
Outdoor NEMA 3R enclosure, IP 43 (rain-tight)
Wall mount with mounting hardware
Convection with cast aluminum heat sink
Transducer is 0.5 - 4.5 VDC with 5 VDC power supply
100 psi range, 10-foot 3-wire shielded cable
Input wire is 5 feet and pre-wired to controller and motor conduit box
Output wire is 10 feet of 14 gauge cable. Cable is prewired to controller and pump motor
Pump e-HM Features
Capacity to 12 GPM
Right hand clockwise rotation, viewed from motor end
316L stainless steel for all liquid handling components
Motor, 1 HP, TEFC, three Phase, 208-230/460V
1" NPT connection and discharge
Maximum temperature of water is 120°F
Pump liquid temperature limit is 212°F
Maximum system working pressure is 145 psi
Carbon / silicon carbide / EPR seal
Overload protection, starters, heaters not required
Applications
Low water pressure applications
Domestic and light commercial applications
Homes with multiple showers/baths
Irrigation
Note:
Tank liquid temperature limit is 120°F. Pump liquid temperature limit is 212°F
Photo is illustrative and may not reflect the actual product.